11
EN
a. Rest the suction unit on a flat surface and thread
the lower part of the hood onto it.
b. Make all the electrical connections between the two
parts.
c. Fix the hood definitively to the suction unit with the
number and type of screws indicated in the figure.
1. Using a pencil, draw a line on the wall, extending
up to the ceiling, to mark the centre. This will
facilitate installation.
2. Rest the drilling template against the wall: the
vertical centre line printed on the drilling template
must correspond to the centre line drawn on the
wall, and the bottom edge of the drilling template
must correspond to the bottom edge of the hood.
3. Rest the support bracket on the drilling template so
that it coincides with the dotted rectangle, mark the
two outer holes and drill them, remove the drilling
template, insert 2 wall plugs and fix the hood
support bracket into place using two 5x45mm
screws.
4. Hang the hood on the bracket.
5. Adjust the distance of the hood from the wall.
6. Adjust the horizontal position of the hood.
7. Using a pencil mark the cooker hood permanent
drill hole inside the suction group (two drill holes
are necessary for fastening).
8. Remove the hood from the bracket.
9. Drill at the point marked (Ø8mm - see operation 7).
10. Insert 2 wall plugs.
11.Rest the chimney support bracket „G“ against the
wall, touching the ceiling. Use the support bracket
as a drilling template (the small slot formed on the
support must coincide with the line drawn on the
wall as above – operation 1) and mark 2 holes with
a pencil, drill the holes (Ø8mm), insert 2 wall plugs.
12.Fix the chimney support bracket to the wall using
two 5x45mm screws.
13.Hook the hood onto the bottom bracket.
14.Fix the hood into its final position on the wall
(ABSOLUTELY ESSENTIAL).
15.Connect a pipe (pipe and pipe clamps not
provided, to be purchased separately) for
discharge of fumes to the connection ring located
over the suction motor unit.
If the hood is to be used in ducting version, the
other end of the pipe must be connected to a
device expelling the fumes to the outside. If the
hood is to be used in filter version, then fix the
deflector F to the chimney support bracket G and
connect the other extremity of the pipe to the
connection ring placed on the deflector F.
16.Make the electrical connections.
17.Apply the chimney stacks and fasten them at the
top to the chimney support „G“ (17b) using 2
screws (17a).
18.Slide the bottom section of the chimney down until it
completely covers the suction unit and slots into the
housing provided on top of the hood.
19. Fix the lower stack of the chimney with 2 screws.
Remount the carbon filter frame and the fat/s filter/s
and check the perfect functioning of the hood.
