SCHOLTES SOHD1600B, Instruction Manual/Safety Instruction

28

Remote control coding

The supplied remote control is already coded and can be used from the beginning 

for total control of the hood. In the event of replacement of the remote control, or to 

encode other remote controls, keep button C1 pressed on the electronic board inside 

the hood 

(Fig. 10)

 for 4 seconds until the red programming LED C2 lights up with a 

fixed light, at this point, immediately press the T1 button on the remote control once 

and the LED will start to flash. When the LED turns off, the programming is finished 

and it will no longer be possible to program the remote control.

Restoring Factory Conditions (Reset)

Keep button C1 on the electronic board inside the hood pressed

 (Fig. 10) 

until the red 

programming LED (C2) lights up and continue to press button C1 without releasing 

until the LED (C2) goes out. At this point no remote control will be coupled and it will 

be necessary to pair one again.

Emergency button

In case of loss of the remote-control or low power of the remote-control battery, the 

hood can be switched on and off using the button (C1) indicated in 

(Fig. 10).

Delayed self-switching off

This function allows you to program delayed cooker hood shutdown after the end of 

the cooking phase which, in the shortest time possible, provides the right level of air 

purity in your kitchen.

Auto power off is already preset at 15 minutes and at the first speed. After the 15 

minutes have elapsed, the motor and the lighting switch off automatically. 

To activate it, hold down the T5 key for a long time while the hood is switched on at 

any speed.

Light indicator for grease filter maintenance

Every 30 hours of operation of the hood, when it is switched off, the hood LED will 

flash for 30 seconds to warn the necessary cleaning of the metal grease filter. 

To reset the timer, simply hold down the (T4) key while the LED is flashing until it is 

switched off. If the timer is not reset, the LED will flash again after each time the hood 

is switched off again.

Plasma filter operation

The correct operation of the plasma filter is indicated by the lighting up of the green 

light inside the motor box

 (Fig.11).

 The filter starts automatically when the air passes, 

if the light turns off with the aspirator running, this would mean a malfunction of the 

filter itself.Contact your after-sales service.