Operation
128
4.5
Data transmission
You can use the following options to transmit data:
l
One of the following options:
– The
AutoStore function (page 119) is used to
periodically (
Int 1 storage interval) save measured
values internally and output them on the interface.
– The
data transmission interval
(Int 2) function is used to
periodically output measured values to the interface
(see below).
l
The
Output data store function (page 121) is used to out-
put calibration data and stored measured values to the in-
terface.
l
The analog recorder output (page 130) is used to output
measured values as voltages.
4.5.1 Data transmission interval (Int 2)
The interval for the data transmission (Int 2) determines the
time interval between automatic data transmissions. After
the time interval expires, the current data record is transmit-
ted to the printer/RS interface.
Note
The setting of the interval (Int 2) only has an effect when the
storage interval (
AutoStore function) is switched off.
Summary of Contents for CG 853P
Page 18: ...Safety 94 ...
Page 28: ...Operation 104 7 Perform an AutoRead measurement according to section 4 2 ...
Page 74: ...Lists 150 ...