SCHOTT
Termofrost
®
SCHOTT
Termofrost
®
Page 3
Warnings
Handling of Schott Termofrost glass doors
Take care when handling the Schott Termofrost doors. Do not place the glass doors on the floor without protection. When
the door is placed on the floor, the
gravity system on the bottom must not touch the ground
to avoid the risk of
damaging it.
Protection of the cabinet during drilling / cutting processes
During drilling works that are done inside of the cabinet the
goods (if present) must be protected to avoid metal spans
falling on them
. Schott recommends the usage of a protective film that serves as a curtain between the working areas
and the inside of the cabinet.
Furthermore the
magnetic gasket should be protected by using the blue protective foam
, that can be clipped around
the bottom gasket. Without this protection the metal spans will get stuck to the magnetic gasket and get rusty in the humid
environment.
Electrical installation instructions
Before installation, maintenance or cleaning, always first switch off or disconnect the power and follow appropriate safety
procedures.
Installations and assembles must be carried out by a professional electrician in accordance with the applicable and
appropriate electrical codes and the instructions provided by SCHOTT.
2. Content of the delivery
Together with each SCHOTT Termofrost
® AGD3 and TAGD3 retrofit set the following componets are delivered
• Doors and frames
• Bottom and upper adapters
• L-console with screws, nuts and washers (delivered only for some fridges)
• Overview showing which frame and adapters is to be used for which line
• Accessories for the finishing on the sides: L-plates, plastic plates, tape
Optional
•
Lights (T5 or LED)
•
Price holders
