13
2. Product description.
2.9 Getting in and out
After all pre-settings have been made, plea-
se first lock all castors, except for the castor
with direction lock (see
Point 2.10.1
), for get-
ting in and out. To do this, press down the lo-
cking device (
A
) on each castor using the tip
of your foot (
B
). To release the castors again
again, push the locking devices up again
with the tip of your foot (
C
).
The brakes only work reliably on an
even surface!
Now bring the reclining surface (
D
) to the
horizontal position (see
Point 3.3 and 3.4
) and adjust the transfer height.
When transferring from a wheelchair, choose a low height, a high one when
doing a transfer from a carrying position. If available, fold the thorax and
pelvis pelotte pads (see
Point 4.3
) to the side and also release the harness
on one side (see
Point 3.8
).
Now you can move the user in the wheelchair / buggy etc. close to the
supine standing frame and lock the wheelchair / buggy. Lift the user out of
the wheelchair / buggy together with a second person or by using a lifter.
Place him on the supine standing frame, close first the harness and then
the thorax and pelvis pelotte pads (if available).
When adjusting the supine standing frame there is the risk of jamming or crus-
hing limbs.
Now you can undertake the fine adjustments on the individual compo-
nents. Please observe here the guidelines on the adjustment of the res-
pective components (see
Point 3
).
Only have the user get in and out of the product on stable and flat ground.
D
A
B
C
