23
3.6 Adapters for leg supports
For
till.
there are two different adapters for
the leg supports (st abductable).
Using the hexagon socket screws (
A
) on the
rear side of
till.,
the level can be adjusted
from 0-5 cm for both variants. For the ab-
ductable variant the angle can also be ad-
justed (see
Point 4.5
).
3.7 Leg length
till.
is available with two leg supports (st flex). Both variants can
be adjusted in length. Compared to the standard version, the flexible leg
(flex) can also be adjusted in its angle (see
point 4.6
).
3.7.1 Leg supports (standard)
For size 1+2
undo the screw (
B
) to adjust the overall length of the leg sup-
port. For optimal positioning of the knee,
release the twist grip (
C
) and bring the leg
support into the desired position.
For size 3+4
undo the screws (
D
+
E
) to adjust
the overall length of the leg support. For an
optimal positioning of the knee, bring the leg
support into the desired position.
3.7.2 Leg supports (flex)
For size 1+2
undo the screws (
F
+
G
) to adjust
the overall length of the leg support. For an
optimal positioning of the knee, bring the leg
support into the desired position.
For size 3+4
undo the screws (
H
+
I
) and the
clamping lever (
J
) to adjust the overall length
of the leg support. For an optimal positioning
of the knee, bring the leg support into the
desired position.
Tighten all screws again after each adjustment!
Clamping levers must not be pressed for actuation for sizes 3+4!
3. Settings.
A
A
B
C
D
E
F
G
I
J
H
