20
3.6 Adapters for leg supports
For
till.
there are two different adapters for
the leg supports (st abductable).
Using the hexagon socket screws (
A
) on the
rear side of
till.,
the level can be adjusted
from 0-5 cm for both variants. For the
abductable variant the angle can also be
adjusted (see
Point 4.5
).
3.7 Leg length
till.
is available with two leg supports
(st flex). Both variants can be
adjusted in length. Compared to the
standard version, the angle of the flexible leg
(flex) can also be adjusted (see
Point 4.6
).
For the
"standard"
version undo the screws
(
B
) to adjust the overall length of the leg.
For optimal positioning of the knee, release
the twist grip (
C
) and bring the leg into the
desired position.
For the
"flex"
version there are two setting screws that are essential for
the length adjustment of the leg. If you loosen the upper hexagon socket
screw (
D
), you can lengthen or shorten the thigh dimensions by pulling or
pushing. When you loosen the lower screw (
E
) you can bring the lower leg
dimensions to the desired length.
Tighten all screws again after each adjustment!
3. Settings.
D
E
B
C
A
A
