47
8.
Connect the hose again.
9.
Turn the water tap on and make sure that no water
escapes.
10.
Turn the water tap off.
On machines with Water Stop
3.
Switch off the mains power supply.
4.
Unscrew the hose only from the water tap.
5.
Pull out filter using a pair of flatnose pliers. Clean and
reinsert it.
6.
Connect the hose again.
7.
Turn the water tap on and make sure that no water
escapes.
8.
Turn the water tap off.
Problems
Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualified specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.
Please find below minor faults which you can rectify
yourself.
Error messages on the display
If the following error messages are displayed, the pro-
gramme can be restarted by pressing the start button
once the error has been rectified.
«CHILD LOCK ACTIVE»
X
Hold the quick wash button down and press the start
button.
«PLEASE CLOSE DOOR»
X
Push the door closed until the lock catches properly.
«PLEASE START AGAIN»
X
If the door was closed subsequently, the Start button
must be pressed again.
«CHECK WATER INLET»
X
Turn on the tap and start again.
X
Filter in water supply is blocked: Clean the filter, see
chapter «Cleaning and Maintenance/Cleaning the filter
in the water inlet».
X
Interruption in water supply.
«CHECK WATER OUTLET»
X
Check whether the drainage hose is blocked.
X
Foreign bodies block the drain pump: clean pump
according to chapter «Cleaning and Maintenance/Emer-
gency emptying».
X
The water drain provided by the customer is blocked:
Carry out an emergency discharge according to chapter
«Cleaning and Maintenance» and clean the drain si-
phon (built-in siphon).
X
The position of the drain hose is too high. The maxi-
mum pumping height is 1m above ground.
«UNBALANCE NO SPINNING»
X
Excessive imbalance. Laundry not spun.
X
Press the start button and then the quick wash button
to end the wash programme.
X
Open the door and redistribute the load.
X
Repeat the spin cycle with the separate spin programme.
General information:
X
Avoid loading the drum with one single heavy item.
Wash large and small laundry together.
«FOAM PROG. ExTEND»
X
The washing machine has detected foam and taken
adequate measures. The spinning cycle of the laundry
could be completed.
In future, please reduce the detergent quantity.
