35
MAChINE OPERATION
Machine does not
start when pressing
the On / Off
button
►
Check whether the mains power is switched on (wall / plug).
►
Check whether all the fuses are intact or the safety switch
has tripped.
Mains blockage (generally at noon).
►
Operate the machine after the mains blockage has ended.
►
If the dryer does not start despite correct power supply,
contact customer service.
The dryer
does not start
►
Press button
.
►
If the programme does not start despite pressing the start
button, contact customer services.
Notice
When time preset is activated, the programme starts only
at the pre-selected time.
The drying target
was not achieved
When warm, laundry feels more moist than it actually is!
►
Remove the laundry from the dryer and let it cool.
When still moist:
►
Clean the fluff filters (see
Drying / Cleaning the fluff
filters
).
►
Increase degree of drying (see
Settings / Dryness level
raised
).
►
Clean the moisture sensor (see
Cleaning and Mainte-
nance / Cleaning the moisture sensor
).
The individual laundry
piece does not reach
the set drying target
►
If one single piece is to be dried in the dryer, it will be dried
more evenly by adding additional pieces, e.g. two terry towels.
The drying takes
too long
►
Clean the fluff filters (see
Drying / Cleaning the fluff
filters
).
Power failure.
►
Note lock times of EW.
The laundry is not dry
after the maximum
possible settings
Drum is overloaded.
►
Observe the maximum loads in the programme table.
Insufficient room ventilation.
►
Open a window or door.