WSI 100 / 125 / 150 / 200 / 250 / 300
page
23
3.3
Programme selection
Standard programmes
You can choose between standard and special programmes.
The standard programmes are selected with the function keys
1- 6
.
The programme selected appears in the text display.
After selecting the programme, you can start the machine with the Start
button
12
.
The 13 standard programmes are listed in section 3.12.
Special programmes Commerce
There are 20 further special commercial programmes at your disposal. They are filed under
the programme numbers 01 - 20 and they can be selected as described below.
A further 50 individual special programmes are also selected by entering the programme
number. These 50 special programmes are washing programmes transmitted by
WSI-CARDs into the machine or programmes programmed directly on the machine.
See also under section 3.13.
3.4
Programme correction
In the event of selecting the wrong programme, press the cancel button "C"
15
and select
the programme once again.
3.5
Programme start and programme interruption
The washing programme selected is started by pressing the Start/Stop button
12
.
You can interrupt and restart a programme in progress by pressing Start/Stop button once
again.
3.6
Emergency Off switch
The Emergency Off switch
18
may only be used in case of danger and causes an immediate
stoppage of the extractor. The switch remains locked in the activated state.
Please do not use the Emergency Off switch in normal operation to stop the machine!
The activated Emergency Off switch can be unlocked after remedying the fault or elimination
of the danger by turning the red mushroom button to the right.
In order to put the machine back into operation again, unlock the Emergency Off switch and
press the Start/Stop button
12
.
3.7
Preset time
With the preset time button
10,
the start of the washing programme selected can be delayed
for max. 99 hours.
The delaying time can be set in 0.5 hour steps by means of the cursor buttons
14
.
After activating the Start/Stop button
12,
the washing machine will not start until after
the delay time set. The time remaining until the start is shown in the text display
17
.
Repeated actuation of the Start button will cause the programme to start immediately.
