4.7
Instructions for replacement of the main fuse
If the machine does not work when switched on, the main switch lights up and the display does not show any values, check the main fuse. The
main fuse (6 A) is located at the back of the machine. Replacement of the main fuse must be carried out by an authorised person, after consulting
the failure with the machine supplier. To replace the fuse, switch off the machine and pull the plug out of the power socket. Open the fuse holder
(picture 1).
Picture 2 shows two fuses:
- Fuse B is a spare fuse.
- Fuse A is connected to the electrical circuit of the machine.
Pull both fuses out of the holder
(picture 3)
.
I
nsert fuse B in place of fuse A and close the fuse holder.
A
B
4.5
Tank filter change
If precoating or water does not flow smoothly to the nozzles, check the filter and replace it if necessary. Open the side cover of the unit. The filters
are located in the tanks
(picture 1)
. Remove the hose from the tank
(picture 2)
and replace the filter
(picture 3).
4.6
Carriage filter cleaning
The machine is equipped with a filter located on the carriage. It should be cleaned in regular intervals.
4
.4
Pump cleaning
To clean the pumps and hoses of the machine, press the „Menu”
(picture 1)
, select the "Maintenance"
(picture 2)
and then "Pump cleaning"
(picture 3).
Follow the instructions shown on the display.
E
N
G
L
IS
H
29
Version
2
2
.0
1
1
2
3
1
2
3
1
2
3
1
2
3
Summary of Contents for PRETREATmaker 5
