Schumacher CR2, Owner'S Manual

•

 4 

•

6.  CONTROL PANEL

LED Display
A.C. POWER

(red) LED lit:  

There is AC power supplied to the battery charger.

CHARGING 

 (yellow) LED lit:  

The charger is charging the battery.

CHARGING 

 (yellow) LED flashing: 

The charger is in abort mode.

CHARGED 

 (green) LED lit: 

The battery is fully charged and the charger is in maintain mode

.

CHARGED 

 (green) LED flashing: 

The battery is 80% charged and is ready to use.

7.  OPERATING INSTRUCTIONS

This battery charger must be properly assembled in accordance with the 

assembly instructions before it is used. 

Battery Information

This charger can be used with 16 and 24V batteries; it automatically detects your battery type.

Charging

NOTE:

 Examine the battery for excessive wear, cracks, bulging or damage each time you 

charge it. If damage is detected, do not charge the battery, replace it immediately. If the 

battery is hot, allow it to cool before charging.

1. 

Connect the battery following the ride-on toy’s instruction manual.

2. 

Connect the AC power following the precautions listed in section 3.

3. 

If you’ve connected everything correctly, the CHARGING 

LED should be lit, 

indicating that the charger is charging.

This charger does not have an ON/OFF switch. ON and OFF are 

controlled by plugging in the charger to the AC wall outlet. The charger will 

not supply current to the battery clips until a battery is properly connected. The clips will 

not spark if touched together.

Using the Quick Cable XLR Connector

1. 

Connect the output cable assembly to the charger. Make sure to place the charger 

on a dry, non-flammable surface, such as metal or concrete.

2. 

With the charger disconnected from the wall outlet, connect the supplied harness 

assembly by connecting the yellow connector to the yellow connector on the end of 

the charger cable. Connect the other end of the cable assembly to the battery.  

NOTE: See Replacement Parts for more connector information.

NOTE:

 Never connect the output cable assemblies together for use in other applications, 

such as external battery or other power source charging, or to extend the output cable 

length, as reverse polarity and/or overcharge conditions will occur. 

Quick Charge 

When the CHARGED 

LED begins to flash, the battery is ready to use. Unplug the 

charger from the wall outlet and then disconnect the charger from the battery. NOTE: The 

CHARGING 

LED will remain lit while the CHARGED 

LED is flashing. 

Complete Charge 

When the CHARGED 

LED stops flashing and stays lit and the CHARGING 

LED 

turns off, the battery is completely charged and the charger has stopped charging and 

switched to the Maintain Mode of operation. When ready to use, unplug the charger from 

the wall outlet and then disconnect the charger from the battery. 

NOTE: 

For longer battery life, the battery must be completely charged after two 

consecutive quick charges. (Example: quick-quick-complete.)