8. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
The unit won’t jump start
my car.
Clamps are not making
a good connection to the
battery.
Connections are reversed.
The internal battery is not
charged.
The vehicle’s battery is
defective.
The unit is not turned on.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the unit and reverse
the clamps.
Press the Battery Status button
on the front of the unit. The LEDs
will indicate the status of charge.
Have the battery checked.
Turn the unit’s ON/OFF
switch to the ON position.
The unit won’t power my
12V device.
The 12V device is not
turned on.
The internal battery is not
charged.
The 12V device draws more
than 20A, has a short circuit,
or the internal fuse has blown.
Turn on the 12V device.
Check the battery charge status
by pressing the Battery Status
button.
Disconnect the 12V device.
The internal 20A fuse needs
replacement by a qualified
service person.
The internal battery won’t
hold a charge.
The battery is bad (will not
accept a charge).
Have the battery checked.
The compressor shuts off.
The compressor is
overheated.
Allow to cool for a few minutes,
then try again.
9
. SPECIFICATIONS
Internal battery type ........................................ Sealed, maintenance-free, AGM, lead-acid
Nominal voltage ......................................................................................................12V DC
12V DC power output....................................................................................................20A
10
.
REPLACEMENT PARTS
Air compressor accessory kit (3 hose adapters) ....................................... 2299001425Z
11.
ACCESSORIES
Male-to-male accessory cable ........................................................................ 94500109
View other automotive tools made by Schumacher on our website.
