Assembly
01.00|1416054_ROTA-M2 + 2 |en
33
Assembly preparation for lathe chuck with direct mounting
If the bolt pitch circle of the short taper machine spindle is
identical to that of the lathe chuck, a direct mount must be used.
Fasten the direct mount to the lathe chuck prior to lathe chuck
assembly.
1 Before mounting the direct mount on the cylindrical recess of
the lathe chuck, remove dirt or chips from the centering
mount and the contact surface of the direct mount.
2 Tighten the direct mount slightly on the lathe chuck with the
supplied fixing screws.
3 The lathe chuck assembly follows
5.3.3
