Assembly
30
01.00|1416054_ROTA-M2 + 2 |en
Testing the spindle nose
The machine side must be aligned prior to the installation in order
to achieve high run-out accuracy of the lathe chuck. To do this,
check the contact surfaces on the spindle for axial and radial run-
out accuracy using a dial indicator.
The concentricity error of the locating centering of the mount
must not exceed 0.005 mm and the maximum axial run-out error
of the contact surfaces must not exceed 0.005 mm. The flat
surface of the spindle must also be checked for flatness using a
straight edge.
Make sure that the surface area of the flat surface is deburred at
the bore holes and is clean.
Assembly
Lathe chuck assembly
5.2
5.3
