Maintenance
01.00 | AGE-U | Assembly and Operating manual | en | 1393226
37
Disassembling the product
8.3 Changing the overload pins, compression springs and
workpiece stop
Disassembling
■
Product has been removed,
Ø
Loosen the screws (10) and remove the tool plate (9).
Ø
Remove and discard the overload pins (8).
Ø
Remove the tool-side housing (6) and place it in a suitable
assembly location.
Ø
Remove and discard the conical compression springs (4) and
beveled washers (7).
Ø
Remove and discard the workpiece stop (5).
Ø
Using a clean cloth, remove any grease and dirt from the holes
and surfaces of the tool plate (9), housing (6), and piston
cover (2).