Assembly and settings
38
04.00 - FW 2.x | EGL | Assembly and Operating Manual | en | 389661
5.5 Combining several products (PROFIBUS, CAN bus)
This chapter describes the combination of products for the EGL
PROFIBUS or EGL CAN bus variants.
Combining multiple products
1
Bus cable 1
5
Product n+1
2
Bus cable 2
6
Product n
3
Terminating resistor
(only for PROFIBUS or CAN
bus)
7
PROFIBUS or CAN bus
connector
4
PROFIBUS or CAN bus
socket
When multiple products are combined, the signals are looped
through from product "n" to product "n+1".
Ø
Plug bus cable 2 from the socket of the product "n" onto the
connector of product "n+1".
Ø
On the last product, plug the termination resistor onto the
socket.
5.6 Setting the baud rate (CAN bus)
The baud rate is only set for variants with CAN bus. The baud rate
is set via DIP switches "4" and "5",
28]. The following settings are possible:
DIP switch 4
DIP switch 5
Baud rate
OFF
OFF
125 kbaud
ON
OFF
250 kbaud
OFF
ON
500 kbaud
ON
ON
1000 kbaud
