Assembly
03.00 | GSM-W | Assembly and operating manual | en | 389108
31
Adjustment of the end position for hydraulic dampening by
means of shock absorbers:
Proceed according to steps 1 to 8 of the elastomer dampening.
Use the shock absorbers (120) instead of the stops (83) and the
shock absorber nut (121) instead of the counter nut (124).
For angles between "0°" and "180°" or "0°" and "90°", insert
additional steel balls (108) in the ball guide rail. The number of
steel balls required and the permissible minimum or maximum
projections, (S variants: shock absorber projections)/(E variants:
back stop projections) can be determined using the table "Total
rotating angle range".
The ball insertion is described in the following chapters:
• for S variants Replacing a shock absorber for S variants
• for E variants Replacing an elastomer for E variants
NOTICE
The permissible minimum and maximum projections are to be
strictly observed; should a rotating angle not be achieved by
adjusting the shock absorbers (120) or stops (83), it must be
done by inserting or removing steel balls (108). However, at
least one ball must be mounted on each side.
Total rotating angle range
Basic size 40
Basic size 64
Standard
total rotating angle range
90° or 180°
Minimum rotating angle range
Can be reduced down to 0° for any position within
the total rotating angle range of the standard unit
Angle limitation per ball [°]
19
13.5
Min. projection A [mm], E variants
3
4.5
Max. projection B [mm], E variants
7
9.5
Min. projection A [mm], S variants
19.5
28
Max. projection B [mm], S variants
23.5
33
