_________________________________________________________________________________________
schunk.com
XND.00034.002_A – 10/2018
30
6
Troubleshooting, eliminating faults
Clamping using the lateral clamping screw (pos. 200) is not possible
The clamping element on the inside is not in the correct position.
See
Section 8 Assembly
Unable to disassemble the carriage unit from the tool body
The clamping screw (pos. 200) has not been unscrewed far enough.
The inside of the vice is very dirty.
→
Clean the entire tool body through the blow-out holes on the front slider after having
disassembled the central jaw. (pos. 70)
Important:
vice functions can exclusively be guaranteed if the central jaw has been installed.
Cylinder screw (pos. 210) has not been removed.
7
Removal
Removing the carriage unit
Removing the system jaws.
Remove the cylinder screw. (pos. 210)
Undo the clamping screw (pos. 200) by a minimum of 4 turns.
Screw (pos. 40) must never be unfastened.
Pull the entire carriage unit from the tool body.
