_________________________________________________________________________________________
www.schunk.de
XND.00018.002_A – 10/2018
19
2
General safety instructions
2.1
Intended use
The clamping device may only be used in accordance with the technical data and has been
designed for stationary application on milling machines in an industrial environment.
Using the device in accordance with the intended purpose includes compliance with the
commissioning, installation and operating instructions, and with the environmental and
service conditions as provided by the manufacturer.
The manufacturer accepts no liability for damage resulting from non-intended use.
2.1.1
Technical:
Exposure to loads in excess of the maximum pull-in torque results in damage
to the spindle.
Weight:
KSC2 40 with reversible jaws:
0.8 kg
KSC2 65 with reversible jaws: 2.9 kg
For further data, please see the current catalogue >> Schunk stationary Workholding <<
2.2
Reasonably foreseeable misapplication
Any application that is not in accordance with the "Intended use" or exceeds such
intended use is considered not in accordance with the regulations, and is forbidden.
Any other use of the device is subject to confirmation from the manufacturer.
Examples of forseeable misapplication:
Clamping device used on rotating systems.
Clamping widely protruding workpieces.
Clamping workpieces with a weight of over 20 kg in vertical position
without an additional safeguard to prevent the item falling out.
Type
max.
torque
max.
clamping force
KSC2 40
20Nm
7kN
KSC2 65
50Nm
15kN
0
5
10
15
20
25
0
1
2
3
4
5
6
7
8
Nm
kN
Anzugsmoment / Spannkraft
KSC2 40
0
10
20
30
40
50
60
0
5
10
15
20
Nm
kN
Anzugsmoment / Spannkraft
KSC2 65
