Basic safety notes
02.00|NSL3 turn 450-3, 450-3-Z, 570-5, 570-5-Z |en
15
Holding force and screw strength
The holding force of the System is essentially limited by the
strength of the screwed connections with which the clamping pin
is connected to the pallet or device. On this basis fastening
screws of the property class 12.9 are to be used only.
Only original SCHUNK Clamping-Pins are to be used.
When the clamping pin is used in the customer’s own assembly
device, the customer is to provide for a sufficiently dimensioned
tap and satisfactory strength of the fastening material.
Protection during handling and assembly
Incorrect handling and assembly
Incorrect handling and assembly may impair the product's safety
and cause serious injuries and considerable material damage.
•
Have all work carried out by appropriately qualified personnel.
•
For all work, secure the product against accidental operation.
•
Observe the relevant accident prevention rules.
•
Use suitable assembly and transport equipment and take
precautions to prevent jamming and crushing.
Incorrect lifting of loads
Falling loads may cause serious injuries and even death.
•
Stand clear of suspended loads and do not step into their
swiveling range.
•
Never move loads without supervision.
•
Do not leave suspended loads unattended.
Protection during commissioning and operation
Falling or violently ejected components
Falling and violently ejected components can cause serious injuries
and even death.
•
Take appropriate protective measures to secure the danger
zone.
•
Never step into the danger zone during operation.
2.12.1
2.12.2
2.12.3
