Assembly
22
09.00 | NSR maxi 220 / PKL maxi 220 | VERO-S robot coupling for pallet
handling | en | 0489051
The air connection takes place using the G1/8" coupling holes at
the side (as standard). The pneumatics screw connections included
in the scope of delivery, or any pneumatics screw connections, can
be fitted for the air supply.
There is an alternative connection option via two M6 connections
on the base side for unlocking and turbo. In this case, the side
connections must be sealed off with the G1/8" locking screws from
the accessory pack. If this connection version is chosen, the direct
connections on the base side, without a hose, must each be sealed
with an O-ring. The accessory pack for the NSR maxi 220 contains
the Ø 9 x 1.5 O-rings (see chapter "Assembly
Drawings"
, item 28 ) for sealing the bottom hose-free
direct connections.
When the turbo connection is used, the spring-actuated locking
procedure is actively supported with air pressure. If the turbo
connection is not used, the relevant side of the piston must be
able to ventilate.
To operate the robot coupling, the support of the turbo function
is generally recommended.
6.3.1 Unlocking Connection
If compressed air is constantly applied to the unlocking connection
of the robot coupling, the clamping system is unlocked. The
clamping pallet can be removed or inserted on the module for
stationary use/ application via the adapted pallet coupling.
There is the option of controlling the clamping system either via
the side G1/8" air connection hole or a hose-free direct connection
on the base side. The air connection that is not connected must be
sealed air-tight with a G1/8" locking screw or an M6 set-screw (on
the base side) (see chapter "Assembly Drawings"
