Assembly
32
02.00 | PLG | Assembly and Operating Manual | en | 1517334
6.3.2 Mounting the inductive proximity switch
NOTICE
Risk of damage to the sensor during assembly!
•
Observe the maximal tightening torque.
Mounting and adjusting the sensor
Note: If the product has been configured with sensors, steps 1-3
are omitted.
1. Loosen the screw (4) on the bracket (2).
2. Slide the sensor (1) to the stop in the bracket (2).
3. Tighten the screw (4) on the bracket (2).
✓
Tightening torque: 0.2 Nm
4. Put product in the position in which it is to be set.
5. Push the bracket (2) together with the sensor (1) to the left
end of the sensor rail (5). Slowly move the bracket (2) to the
right so that the sensor switches.
Secure the bracket (2) in this position with screw (3).
✓
Tightening torque: 0.2 Nm
