Assembly
22
06.00|PZB-plus |en
Position of the magnetic switch
Gripper open:
1 Set the gripper to the „Open“ position.
2 Slide the magnetic switch 1 (8) into the groove (12) until it
comes into contact with the housing.
3 Slide the magnetic switch 1 (8) slowly back until it switches.
4 By tightening the set screw (9), fix the magnetic switch 1 (8) in
this position in the groove (12).
5 Test the function by closing the gripper and then opening it
again.
Gripper closed:
1 Set the gripper to the „Closed“ position.
2 Slide the magnetic switch 2 (2) into the groove (4) in the direc-
tion of the center of the gripper until it switches.
3 By tightening the set screw (3), fix the magnetic switch 2 (2) in
this position in the groove (4).
4 Test the function by opening the gripper and then closing it
again.
Positioning the
magnetic switch
www.comoso.com