Maintenance and care
32
06.00|PZB-plus |en
Lubricants/Lubrication points
We recommend the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point
Lubricant
Metallic sliding surfaces
microGLEIT GP 360
All seals
Renolit HLT 2
Bores on the piston
Renolit HLT 2
In addition to the described maintenance, the guides of the gripper
can be re-lubricated as needed.
Lubricating nipples can be used instead of the air purge connection.
At the respective air purge connection, remove the set screw and re-
place it with lubricating nipples.
Disassembly of the module
Version without gripping force maintenance
Position of the position numbers
WARNING
Risk of injury when the machine/system moves unexpectedly.
Remove the energy supplies.
1 Remove the compressed air hoses.
2 Loosen the set screws and remove the pressure piece.
3 Remove the cover (5).
4 Mark the installation position of the piston (3/8) and the base
jaws (2) in the housing (50).
5 Unscrew the screws (41) and remove the cover (4).
6 Mark the installation position of the Cylinder piston (6) on the
housing (50).
7 Unscrew the groove nut (13) and remove the cylinder piston (6)
from the housing.
8 Press the piston (3/8) upward out of the housing (50).
9 Pull the base jaws (2) out of the housing (50).
9.3
9.4
9.4.1
www.comoso.com