Assembly
08.00 | PZN-plus | Assembly and Operating Manual | en | 0389374
33
NOTE
The screws (4) and (5) differ in length. With size PZN-plus 380,
these screws on sensor 3 (1) are the same length.
Variant Dust-tight:
Before attaching the sensor, remove the sealing bolts from the
bracket. Before adjusting the control cam, unscrew the set-screw
from the side cover.
Position "Gripper open" or "Part gripped (I.D. gripping)"
Ø
Slide the sensor 1 (1) or sensor 2 (1) to the stop into the bracket
(2).
Ø
Tighten the screw (3) on the bracket (2).
Tightening torque: 0.2 Nm
Ø
Open gripper or grip part.
Ø
Undo the screw (4).
Ø
Turn the screw (5) to push the position of the control cam (6).
✓
Slide control cam (6) inwards until the sensor 1 (1) no longer
responds.
Move the control cam (6) back towards the outside until the
sensor 1 (1) begins to switch.
Ø
Tighten screw (4) and in doing so press the control cam in the
direction of the gripper fingers.
NOTICE! The control cam may
tilt in the guide if it has not been tightened properly.
✓
Switching point is set.
Ø
Bring product into the "Gripper open" or "Part gripped" position
and test the function.