Mounting
32
01 | ROTA NCO2, ROTA NCO2-JA | Power Chuck | en | 1506425
• Then tighten the fastening screws alternately with a torque
wrench. Observe the specified maximum admissible
torques.
• Check radial and axial run-out again.
• Check the actuating force is functioning and is sufficiently large.
• Check the jaw stroke of the base jaws and that these can move
easily.
• Fasten the top jaws marked 1, 2 and 3 to the base jaws using
T-nuts and screws.
The spindle is disassembled in the same way but in the reverse
order.