Assembly
44
04.00|0889132_ROTA TB2 / ROTA TB2 LH |en
Mechanical monitoring
Mechanical stroke monitoring with inductive proximity
switches on dual stroke chucks
The mechanical path control is prepared for each lathe chuck with
rapid and clamping stroke (long stroke version).
For lathes on which the monitoring is prepared, the mechanical
path control should be put into operation.
Path control is only possible if the lathe chuck is in a certain
position in the lathe.
The left-hand inductive proximity switch (see Fig. 7 "Mechanical
monitoring") is adjusted so that it just responds in the position in
which the base jaws are radially outward.
The right-hand inductive proximity switch should trigger when the
dimension
"L"
of the control cam has the following dimension:
ROTA TB2 470-185 LH: 29.4 mm
ROTA TB2 520-191 LH: 28.7 mm
ROTA TB2 600-275 LH: 28.1 mm
ROTA TB2 630-275 LH: 24.1 mm
ROTA TB2 850-375 LH: 29.3 mm
ROTA TB2 1000-560LH: 28.8 mm
5.5
