Basic safety notes
04.00|0889132_ROTA TB2 / ROTA TB2 LH |en
15
Caution
Following a longer shutdown period (more than approx. 6 hours),
always re-tension the clamped lathe chuck in order to compensate
for the setting properties of the clamping situation or possible
pressure losses and the resulting loss of clamping force.
Substantial modifications
No substantial modifications may be made to the chuck.
If the operator carries out a substantial modification to the
chuck, the product shall no longer conform to the EC Machinery
Directive 2006/42/EC.
Personnel qualification
Inadequate qualifications of the personnel
If the personnel working with the product is not sufficiently
qualified, the result may be serious injuries and significant
property damage.
•
All work may only be performed by qualified personnel.
•
Before working with the product, the personnel must have read
and understood the complete assembly and operating manual.
•
Observe the national safety regulations and rules and general
safety instructions.
The following personal qualifications are necessary for the various
activities related to the product:
Due to their technical training, knowledge and experience, trained
electricians are able to work on electrical systems, recognize and
avoid possible dangers and know the relevant standards and
regulations.
Due to its technical training, knowledge and experience, qualified
personnel is able to perform the delegated tasks, recognize and
avoid possible dangers and knows the relevant standards and
regulations.
Instructed persons were instructed by the operator about the
delegated tasks and possible dangers due to improper behaviour.
Due to its technical training, knowledge and experience, service
personnel of the manufacturer is able to perform the delegated
tasks and to recognize and avoid possible dangers.
2.6.1
2.7
Trained electrician
Qualified personnel
Instructed person
Service personnel of
the manufacturer
