Product description
01.00|ROTA THW vario |en-US
29
collet chuck is not possible, as no independent clamping force
application is provided.
In the standard version, the vario F is designed in such a way that
the stroke control does not have to be changed over to the vario.
If no workpiece is clamped, the end positions of the power chuck
are monitored. As the vario F does not require the same actuation
stroke, a defined idle stroke is driven over the sliding sleeve for
clamping and unclamping.
If an intermediate position can be programmed at the stroke
control in the clamping cylinder, it would be possible to move with
optimized actuation paths using a special attachment to the vario
F. The attachment of the power chuck remains unaffected.
Important:
The actuating pressure must be adapted for the power chuck and
for the collet chuck when re-equipping the clamping task.
Overview of sizes, vario F
Size
Clamping range of the chuck
Clamping range of the segmented
clamping sleeve
65
from Ø 4 to Ø 65
1 mm increments
±0.5
80
from Ø 5 to Ø 80
1 mm increments
±0.5
100
from Ø 16 to Ø 100
1 mm increments
±1
Summary of Contents for ROTA THWvario
Page 60: ...Assembly drawing 60 01 00 ROTA THW vario en US Assembly drawing ROTA THW vario 215 62 13 13 1 ...
Page 61: ...Assembly drawing 01 00 ROTA THW vario en US 61 ...
Page 62: ...Assembly drawing 62 01 00 ROTA THW vario en US Segmented mandrel ROTA THW vario D 13 1 1 ...
Page 63: ...Assembly drawing 01 00 ROTA THW vario en US 63 Collet chuck ROTA THW vario F 13 1 2 ...