Assembly
01.00|ROTA THW vario |en-US
37
Disassembling and assembling the segmented mandrel
The segmented mandrel can be disassembled only when not
installed.
• Unscrew clamping bolt (item 2) and remove segmented
clamping sleeve.
• Unscrew and remove the stop (item 3).
• By removing the screws (item 12) the idle stroke bolt (item 6)
and the bayonet piece (item 7) can be removed.
• By loosening the radial fixing pin (item 11), the actuating cone
(item 5) can be removed from the mandrel body (item 1).
• The bolt (item 15) and ejector pins (item 4) can be removed
from the mandrel body (item 1).
Clean the individual components and check all parts for damage
and wear.
Only use original SCHUNK spare parts when replacing damaged
parts.
The segmented mandrel is assembled in the same way, but in
reverse order.
8.2.4
Summary of Contents for ROTA THWvario
Page 60: ...Assembly drawing 60 01 00 ROTA THW vario en US Assembly drawing ROTA THW vario 215 62 13 13 1 ...
Page 61: ...Assembly drawing 01 00 ROTA THW vario en US 61 ...
Page 62: ...Assembly drawing 62 01 00 ROTA THW vario en US Segmented mandrel ROTA THW vario D 13 1 1 ...
Page 63: ...Assembly drawing 01 00 ROTA THW vario en US 63 Collet chuck ROTA THW vario F 13 1 2 ...