Maintenance
54
01.00|ROTA THW vario |en-US
When using the clamping device in 3-shift operation, it should be
maintained as follows:
•
After every 22 operating hours,
the clamping element must be
removed and the taper, coupling and clamping element
(clamping head, segmented clamping sleeve) cleaned and
lubricated.
Special attention must be paid to the coupling area!
• A general visual inspection, especially of the clamping and stop
surfaces, must also be carried out to detect damage to the
clamping device and the rubber of the clamping element at an
early stage.
• The seals in the segmented clamping sleeve must be checked
for damage during the maintenance and cleaning intervals and
replaced if necessary.
Only use original SCHUNK spare parts.
• Depending on the amount of dirt, a complete cleaning of all
moving parts should be carried out.
• Approx.
2 times a year
the clamping device must be cleaned of
coolant and the surface must be protected against rust with a
preserving agent.
• Clean the coupling area of dirt
daily or more if necessary
.
Summary of Contents for ROTA THWvario
Page 60: ...Assembly drawing 60 01 00 ROTA THW vario en US Assembly drawing ROTA THW vario 215 62 13 13 1 ...
Page 61: ...Assembly drawing 01 00 ROTA THW vario en US 61 ...
Page 62: ...Assembly drawing 62 01 00 ROTA THW vario en US Segmented mandrel ROTA THW vario D 13 1 1 ...
Page 63: ...Assembly drawing 01 00 ROTA THW vario en US 63 Collet chuck ROTA THW vario F 13 1 2 ...