Accessories
68
01.00|ROTA THW vario |en-US
To change the stops, see the chapter "Changing the stops" Link
Koppelschnittstelle
Connection data
Size 0
Inside pass Ø: 32 H7
Total length: 30 mm
Outside Ø: 65 mm
Pitch circle Ø: 50 mm
Connection data
Size 1
Inside pass Ø: 41 H7
Total length: 37 mm
Outside Ø: 69 mm
Pitch circle Ø: 55 mm
Connection data
Size 2
Inside pass Ø: 50 H7
Total length: 55 mm
Outside Ø: 93 mm
Pitch circle Ø: 78 mm
Connection data
Size 3
Inside pass Ø: 65 H7
Total length: 63 mm
Outside Ø: 96 mm
Pitch circle Ø: 80 mm
Mandrex
The MANDREX cartridge is for compensating clamping of non-
round workpieces.
• The bore to be clamped must not have a groove or recess.
• The bore tolerance should not exceed 0.3 mm.
• The ideal situation is for the workpiece bore to fully cover the
MANDREX clamping face. If the workpiece bore is shorter
(minimum 1/3 of the clamping face) please inquire.
Standard stops
14.1.3
Prerequisite for the
use of MANDREX:
Summary of Contents for ROTA THWvario
Page 60: ...Assembly drawing 60 01 00 ROTA THW vario en US Assembly drawing ROTA THW vario 215 62 13 13 1 ...
Page 61: ...Assembly drawing 01 00 ROTA THW vario en US 61 ...
Page 62: ...Assembly drawing 62 01 00 ROTA THW vario en US Segmented mandrel ROTA THW vario D 13 1 1 ...
Page 63: ...Assembly drawing 01 00 ROTA THW vario en US 63 Collet chuck ROTA THW vario F 13 1 2 ...
