Assembly and settings
30
03.00 | SRH-plus-D | Assembly and Operating Manual | en | 1424337
NOTE
If the absorber stroke is changed, the swivel speed might also
need to be changed as well, so that the movement remains
smooth,
✓
IMPORTANT! If the stop pin is unscrewed too far, this may
cause the rotary actuator to leak.
By unscrewing stop pin
A
(4), the absorber stroke is
reduced.
✓
By screwing in stop pin
A
(4), the absorber stroke is
increased.
5. Fix stop pin
A
(4) and tighten bolt (3).
6. Fix back stop
A
(2) and tighten bolt (3).
7. Swivel repeatedly to test the setting, set again if necessary.
✓
The end positions must be approached gently.
8. Put on cover cap (4).
9.
On the second shock absorber (6)
Repeat the steps for the other end position.
NOTE
Depending on the loading condition, the settings for the two
shock absorbers may deviate widely from each other.
5.3.4 Diagram of swiveling movement
Optimal setting
Movement
Target position
End position
Target time
Time T
Damping
Swiveling speed and absorber stroke are optimal.
Erroneous
adjustment
Movement
Target position
End position
Target time
Time T
Damping
