Assembly and settings
26
03.00 | SRH-plus-D | Assembly and Operating Manual | en | 1424337
5.3 Settings
CAUTION
Material damage due to erroneous settings!
If the end position is approached too hard, the product may be
damaged.
•
Adjust exhaust throttle valve and shock absorber so that the
movement is braked smoothly.
For operation, the angle of rotation, the swiveling speed and the
absorber stroke must be set.
The settings must always be configured under subsequent
operational conditions. If the operating conditions change, e. g.
weight of the workpiece, check that the movement decelerates
smoothly. If necessary, readjust angle of rotation, swiveling speed
and absorber stroke.
Angle of rotation
The angle of rotation is set in order to achieve a fine adjustment of
the end positions.
If the end positions are adjusted, the swiveling speed and absorber
stroke might also have to be readjusted.
Swiveling speed and
absorber stroke
In order to ensure a smooth operating cycle for the respective
operating conditions, swivel speed and absorber stroke must be
attuned to one another,
.
Each end position is set separately. The position of the exhaust
throttle valve and shock absorber may deviate from one another.
5.3.1 Adjust swivel angle
The angle of rotation is set in order to attain a fine adjustment of
the end positions. The end positions can be adjusted by ±3°.
Adjustment range
Piston
Adjustment range/
Final angle
Swivel range
Adjustment range/
Final angle
Centring sleeves
Piston
End position adjustability 3°
