Assembly
For the variants with pneumatic and locked center position, air
supply throttle valves must be mounted to various air
connections,
. The sequence for setting the swivel
speed with the air supply throttle valve is identical to the sequence
with mounted exhaust throttle valve.
In addition to air connections
A
and
B
the air connections
C
and
D
must also be set for the variants with pneumatic and locked center
position.
For the variant with locked center position and separate piston
chambers, the air connections
A1
,
A2
,
B1
and
B2
must be set.
5.4.3 Adjust absorber stroke
CAUTION
Material damage to the product possible!
If the maximum adjustment range of the absorber stroke is
exceeded, this can cause leaks in the product.
•
When setting the absorber stroke, adhere to the maximum
adjustment range.
Designation
SRU-plus-D
20
25
30
35
40
50
60
Max. adjustment range
[mm]
7.5 7.5 7.5 6.5 6.5 10.5 10.5
1. Check deceleration of the movement in the end positions.
✓
If the absorber stroke is too long, the end position is
reached too slowly.
✓
If the absorber stroke is too short, the assembly impacts in
the end position.
2.
On the first shock absorber (1):
remove cover (5).
39
04.00 | SRU-plus-D | Assembly and Operating Manual | en | 1380765
Summary of Contents for SRU-plus-D
