22
02.00 | KSF3, KSF3-LH, KSF3-F | Assembly and Operating Manual | en |
1467140
Assembly and connection
5.2.1
Supply lines and lubrication lines
The clamping force block has four air connections:
I, II, III, IV
.
Two connections for OPEN (
I
and
III
) and two connections for
CLOSE (
II
and
IV
).
The application determines which of the two air connections must
be opened for actuation:
•
Connections
I
and
II
for operation without an adapter plate.
•
Connections
III
and
IV
in the base for hose-free direct
connection to the machine table or on the adapter plate.
The threads for hose-free direct connection (III and IV) are not
designed for pneumatic fittings.
Thread for pneumatic fitting (front):
KSF3, KSF3-LH, KS3-F 100
KSF3, KSF3-LH, KSF3-F 160 and 250
NOTE:
M5
G1/8"
All four air connections come sealed on delivery of the clamping
force block. On the base side with set-screws (item 60) and on the
front with locking screws (item 23).
•
When using the air purge via connection 5, the two sound
absorbers (V) must be removed and replaced by set-screws (item
93).
Requirements for compressed air supply: compressed air,
compressed air quality according to ISO 8573-1: 7:4:4
Unconditioned compressed air contains dust and oil particles and
moisture, all of which can lead to malfunctions or premature wear
in the clamping force block. The oiler should be no more than 2
meters from the coupling point.
The clamping force block has two more base connections (
6/7
) for
direct lubrication through the machine table. These connections
come sealed on delivery with set-screws (item 62).
5.2.2
Dynamic pressure monitoring of the jaw end positions (variant
"PM")
Dynamic pressure monitoring for the jaw end positions is
integrated via connections 1 and 4 on the bottom.
Connection 1 → monitoring open jaw position.
Connection 4 → monitoring closed jaw position.
The max. pressure for the monitoring functions is 2 bar.
Limit volumetric flow to 10 l/min.
Pressure difference between stroke end positions min. 1 bar.
Summary of Contents for TANDEM KSF3 100
Page 46: ...SCHUNK ...
Page 47: ...SCHUNK ...
