Assembly
02|NSE-M plus 138 |en
15
NOTE
The evenness in height of the modules on the clamping station is
only guaranteed when clamped.
The clamping station is mounted using the BRR 50 cylindrical
clamp blanks. See the clamping diagram for the arrangement of
the BRR 50 cylindrical clamp blanks.
For questions on clamping stations for manually actuated Quick-
Change Pallet Modules, contact our technical customer service
Clamping pins SPA 40, SPB 40, SPC 40, SPG 40
CAUTION
Notes on clamping pins and fastening screws
The holding force of the quick change pallet system is limited
essentially by the tightness of the screw connection which
connects the clamping pin to the pallet or the device. This is why
only screws of strength class 12.9 may be used.
Only original SCHUNK clamping pins may be used.
If the clamping pins are to be used in customer-owned devices,
the customer must provide sufficiently dimensioned threaded
holes or a sufficiently thick mounting material.
The clamping pins can be fastened onto the workpiece or pallet in
2 different ways, the fastening variations are numbered in the
preferred sequence.
If the clamping pins have to be used for pallets that are not from
SCHUNK, e.g. customer-owned devices or items, the outer
diameter of the piece that has to be strained, has to be chosen at
least so big that the O-ring on the top of the particular quick
change pallet system is entirely covered.
6.4
