Assembly
4 Assembly
4.1 General Installation Notes
Pre-assembly measures
Lift the quick-change pallet system carefully out of the packaging
(e.g. using suitable lifting equipment). For clamping stations NSL3
400 or higher, eye bolts are supplied for transporting the clamping
station. The eye bolts are to be mounted into the transport
threads on the base plate and then removed after assembly.
Before assembly, the interfaces (bottom of the clamping station
and support area of the machine table) must be clean and free of
any contamination or damage.
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
•
Before starting any work on the product: Switch off the power
supply and secure against restarting.
•
Make sure, that no residual energy remains in the system.
CAUTION
Danger of injury due to sharp edges and rough or slippery
surfaces
•
Wear personal protective equipment, particularly protective
gloves.
17
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
