Assembly
22
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
positional orientation of the clamping pallet or for the use of a
clamping membrane type SPM plus 138. The NSL3 150-V1-T has
two G 1/8" connectors for separate functions. One air connection
for unlocking and one air connection for the turbo function. Supply
occurs either via the pneumatic plug connections G1/8" 6/4 or the
sealing nipple for locking couplings type NW 7.4 (accessory). The
clamping station can be retrofitted to the supply points at both air
connections with separately available connection strips
(accessories).
Reduced material
thickness in marked
areas
Bore holes permitted in
shaded areas
NSL3 150-V1-T
4.3.2 NSL3 200
The clamping station can be clamped directly onto the machine
table via screws. Permitted areas for appropriate bore holes can
be found in the attached bore hole drawings. Optionally, BRR 50
clamp banks can be purchased. There are four alignment grooves
on the bottom of the clamping station to mount T-nuts used for
aligning the clamping station. These allow for precise alignment
along an alignment groove. The NSL3 200 is equipped with two
interconnected G 1/8" air connections for simultaneously
unlocking both clamping points. The air supply can be connected
to either the front or the back of the clamping station. The
opposing connection point is closed with a locking screw. Supply
