Assembly
30
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
4.4 Clamping pins SPA 40, SPB 40, SPC 40, SPG 40
CAUTION
Notes on clamping pins and mounting screws
The holding force of the quick-change pallet system is limited
essentially by the tightness of the screw connection which
connects the clamping pin to the pallet or the device. This is why
only screws of strength class 12.9 may be used for connections to
the palette or device.
Only original SCHUNK clamping pins may be used.
If the clamping pins are to be used in customer-owned devices,
the customer must provide sufficiently dimensioned threaded
holes or a sufficiently thick mounting material.
The clamping pins can be attached in two different ways to the
workpiece or pallet; the mounting variants are numbered in order
of preference.
If clamping pins are used outside of SCHUNK pallets, for example
in customer-specific devices or workpieces, the outer diameter of
the part to be clamped must be large enough to completely cover
the plan sealing ring on the top of all quick-change pallet systems
involved in the clamping function.
Type designation ID no.
Min. outer diameter
on the support of the part
NSE3 138(-K)
1313721,
1313722
68 mm
NSE3 138-V1(-K) 1313723,
1313724
68 mm
Screw DIN EN ISO 4762/12.9
Customer-specific pallet or device
Screw DIN EN ISO 4762/12.9
Steel Aluminum
Steel Aluminum
