Assembly
24
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
grooves each. These are intended for positional orientation when
using single clamping pallets types PAL-S, PAL-A or clamping
membranes for workpiece clamping type SPM plus 138. The
clamping station can be retrofitted at the connection points using
a 2x connection strip (accessory).
Reduced material
thickness in marked areas
Reduced material
thickness in marked areas
Bore holes permitted in
shaded areas
NSL3 200-V1-T
4.3.4 NSL3 300-200
The clamping station can be clamped directly onto the machine
table via screws. Permitted areas for appropriate bore holes can
be found in the attached bore hole drawings. Optionally, BRR 50
clamp banks can be purchased. There are four alignment grooves
on the bottom of the clamping station to mount T-nuts used for
aligning the clamping station. These allow for precise alignment
along an alignment groove. The NSL3 300-200 is equipped with a G
1/8" air connection for simultaneously unlocking all three
clamping points. Supply occurs either via a pneumatic plug
connection G1/8" 6/4 or a sealing nipple for locking couplings type
NW 7.4 (accessory). The clamping station can be retrofitted at the
connection points using a separately available connection strip
(accessory).
