Assembly
32
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
Type C clamping pin with
centering clearance 0.1 mm
Type B clamping
pin for positioning in
one direction
Type A clamping pin with
positioning accuracy
Clamping pins type C
Clamping pins
type B
Clamping pallet with 3 clamping areas
4.4.1 Information to clamping pin SPG 40
The SPG 40 can be used with a clamping position instead of the
SPA 40.
With several clamping positions, all three types of clamping pins
can be replaced with the SPG 40.
The repeat accuracy increases to < 0.002 mm when using the SPG
40.
When connecting the screws from above, an M12 screw 10 mm
longer of strength class 12.9 must be used after order of
preference 2.
4.5 Clamping pallets PAL-S, PAL-A (optional)
There are suitable VERO-S clamping pallets to be used as
accessories for NSL3 clamping stations. There are different sized
clamping pallets that correspond to the clamping stations. These
are available in steel as well as aluminum. The clamping pallets
achieve highly accurate repeat accuracy in combination with the
VERO-S NSL3 clamping station.
When using single clamping pallets, these can be placed in a
position-oriented and non-rotating fashion on a single NSE3 138-
V1 clamping module in combination with the NSL3-V1 clamping
station. The positional orientation is achieved using an indexing
pin type IXB V1 NSE plus, which inserts into one of two 90° angled
fitting grooves on the clamping module. Request our installation
drawings if doing the installation yourself.
