Assembly
VERO-S clamping pallets
Indexing pins for positional
orientation
Two fitting grooves on the NSE3 138-V1
clamping module for angular positioning
at 0° and 90°
NSL3 150-V1-T with single clamping pallet
4.6 Screw tightening torques
Tightening torques for mounting clamping pins to the workpiece
or to the clamping pallet.
(Screw quality 12.9)
Screw size
M8
M10 M12 M14 M16
Tightening torques (Nm)
32
62
108
170
262
Tightening torques for fastening the clamping station with BRR50
clamp blanks.
The clamp blanks that have been adjusted by the customer to
correspond to the machine table must be fastened to the machine
table with fastening screws of strength class 10.9. These fixing
screws and any nuts required for the T-slots are not included in the
scope of delivery.
Note:
The clamping stations should preferably be fastened with M12
screws in connection with the clamp blanks.
(Screw quality 10.9)
Screw size
M10
M12
M14
Tightening torques (Nm)
50
88
120
33
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
