OPERATION
Page 25
KEEP WARM FUNCTION
The Keep Warm function allows you to set any zone
to one of three preset ‘ideal’ cooking temperatures:
• 42°C - butter or chocolate melting; keeps ready-
to-serve food warm, retaining taste, and prevent
contents from sticking to the bottom of the pan .
• 70°C - reheating food to ready-to-serve
temperature
• 94°C - maintain rolling boil.
For the Keep Warm function to operate correctly,
use a flat base pot or frying pan, so that the
base temperature is accurately measured by the
temperature sensor fitted in the cooking zone.
The Keep Warm function can be activated for any
cooking zone.
To activate a Keep Warm function:
• 42°C: Touch sensor (3) to select the cooking
zone, then touch Keep Warm function sensor
field (8) and the display will show the “
” symbol
indicating the temperature of 42°C is selected.
• 70°C: Touch Keep Warm function sensor field (8)
again and the second “
” symbol will be shown
indicating the temperature of 70°C is selected.
• 94°C: Touch Keep Warm function sensor field
(8) again and the third “
” symbol will be shown
indicating the temperature of 94°C is selected.
To turn off the Keep Warm function:
• To turn off the Keep Warm function at any time
touch sensor (3), and then slide across the
sensor (2) to reduce heat setting to “
” .
STOP ‘N’ GO FUNCTION
“
”
Stop ‘n’ go function acts like a ‘pause button’. It
simultaneously suspends operation of all cooking
zones and then resumes at the heat settings that
were previously set.
To activate the Stop ‘n’ go function:
In order to activate the Stop ‘n’ go function, at least
one cooking zone must be in use.
Next, touch the Stop ‘n’ go function sensor field (7).
“
” will be shown on all cooking zone displays (3).
When a cooking zone is still hot, the “
” symbol will
alternate between “
” and “
” indicating residual
heat in a given cooking zone.
To activate the Stop ‘n’ go function:
To deactivate the Stop ‘n’ go function, touch the (7)
sensor field again. The cooking zone displays (3)
will show the heat setting that was previously set
before activation of the Stop ‘n’ go function.
BRIDGE FUNCTION
The Bridge function allows pairing of two cooking
zones into a single combined cooking zone. The
Bridge function is very convenient, especially when
cooking with very large pots, grill skillets or baking
pans.
Note: The two left cooking zones can be bridged.
In order to activate the Bridge function, touch
the cooking zone sensor field (3) and then
simultaneously touch two sensors of both left side
cooking zones (3). The rear cooking zone will display
“
” , while the front cooking zone will display “
” .
The desired heat setting is selected by sliding your
finger across the setting selection sensor field (2).
Both cooking zones can now be controlled at
the same time.
In order to deactivate the Bridge function, touch
and hold the cooking zone sensor (3) with symbol
“
” for 3 seconds. The respective cooking zone
displays will show “
” .
Both cooking zones can now be controlled
independently.
Summary of Contents for INID77
Page 31: ...Page 31 NOTES...
