4.1
KY 96A/196A VHF COMM. TRANS CEIVER
To turn on the ra dio ro tate the Vol ume (VOL) knob clock wise
from the OFF po si tion. When power is ac ti vated the USE and
Standby (STBY) win dows will dis play the fre quen cies and/or
mode stored in the non-vol a tile mem ory be fore power down.
Af ter ac ti vat ing power, pull the VOL knob out to over ride the au -
to matic squelch and ro tate the VOL knob to the de sired au dio
level. Push the VOL knob back in to ac ti vate the au to matic
squelch.
TRANS MIT IN DI CA TOR
Dur ing Comm trans mis sions, a TX (KY96A) or a T (KY 196A)
will ap pear be tween the USE and STBY win dows to in di cate that
the trans ceiver is in the Trans mit mode of op er a tion:
KY 96A COMM Trans ceiver [TSO’d]
MODES OF OP ER A TION
A. Fre quency Mode
Fre quency se lec tion is ac com plished in the Standby En try mode by
chang ing the fre quency dis play in the STBY win dow of the dis play
with the tun ing knobs, and then trans fer ring the se lected fre quency
into the USE win dow by press ing the Trans fer but ton. The larger
tun ing knob will in cre ment or dec re ment the MH
Z
por tion of the
dis play in 1 MH
Z
steps with roll over at each band edge (118.000
MH
Z
or 136.975 MH
Z
). The smaller tun ing knob will in cre ment or
dec re ment the KH
Z
por tion of the dis play in 50 KH
Z
steps with the
knob pushed in, or in 25 KH
Z
steps with the knob pulled out.
While in the Standby En try mode, the trans ceiver re mains tuned to
the fre quency dis played in the USE win dow at all times.
SCHWEIZER MODEL 269C-1 HELICOPTER
CSP-C1-1A
FAA Approved: 03 Oct 1995
9
Revised: 17 Apr 1996
