16
9.
To loosen the Flywheel hardware (D), use a 15mm open end wrench
to hold the nut on one side steady and loosen the nut on the opposite
side with a 15mm socket and wrench.
10.
Move the Flywheel in the Main Frame bracket as necessary to
adjust the tension. Hold it in position and tighten the hardware.
Note:
This step may require two people.
To tighten the Flywheel hardware, use a 15mm open end wrench
to hold the nut on one side steady and tighten the nut on the
opposite side with a 15mm socket and wrench.
11.
Carefully turn the crank arms and check the movement of the drive
belt. The Crank Arms and Flywheel should move as one.
!
Be sure to keep fi ngers clear of all pinch hazards when you
turn the Drive Pulley.
Adjust the belt tension again if necessary.
12.
Remove the cardboard from the Brake Assembly (if present).
8.
Insert 2.5” x 10” cardboard between the Brake Magnet (C) and the
Flywheel (B), and tape the cardboard to the Brake Magnet.
Note:
Be sure the cardboard covers all of the Brake Magnet.
C
B
B
D
