Schwinn 425 Elliptical, Assembly Manual

31

Console shuts off (enters 
sleep mode) while in use

Check data cable integrity

All wires in the cable should be intact. If any are cut or 
crimped, replace cable.

Check data cable
connections/orientation

Be sure cable is connected securely and oriented properly. 
Small latch on connector should line up and snap into place.

Reset machine

Unplug unit from electrical outlet for 3 minutes. Reconnect to 
outlet. 

Check magnet position  

(requires shroud removal)

Magnet should be in place on pulley. 

Check RPM Sensor 

(requires shroud removal)

RPM sensor should be aligned with magnet and connected 
to data cable.  Re-align sensor if necessary, replace if any 
damage to sensor or connecting wire.

Fan (if equipped) will not 

turn on or will not turn off

Check data cable integrity

All wires in cable should be intact. If any are cut or crimped, 
replace cable.

Check data cable 
connections/orientation

Be sure cable is connected securely and oriented properly. 
Small latch on connector should line up and snap into place.

Reset machine

Unplug unit from electrical outlet for 3 minutes. Reconnect to 
outlet.

Unit rocks/does not sit 
level

Check leveler adjustment

Leveling feet may be turned in or out to level the machine.

Check surface under unit

Adjustment may not be able to compensate for extremely 

uneven surfaces. Move the machine to level area.

Resistance does not 
change

Check that unit powers up

If machine powers up and otherwise functions normally, 
contact Customer Care for assistance.

Drive train click/tick noise 
once per full crank revolu-
tion

Check crank/pulley 
assembly

Disconnect left and right foot assemblies and rotate crank. 
If sound persists, replace crank/pulley assembly.  If sound 
does not come from rotating crank, check foot assemblies 
and upper/lower handlebars.

Check foot assemblies, 
leg assemblies, handlebar 
assemblies

Manually move foot, leg, and handlebar assemblies to isolate 
sound.  Replace part making sound.

Squeaking noise that 

appears a few minutes into 
a workout and normally will 
get progressively worse as 
the workout continues

Bolt that connects the 

swing arms to the axle 

running through the 
console mast

Loosen pivot rod bolt slightly until noise goes away.  See 
video for demonstration.  White lithium grease can also be 

applied for a temporary fix. Contact Customer Care for as

-

sistance.