11
Note:
Your machine may not match the image. For reference only.
Tools required:
6 mm hex key
1.
Loosen and remove the Hardware (A) that attaches the Footpeg
and Handlebar to the Arm Pivot. Set the hardware safely aside
for reassembly.
To prevent possible serious injury, hold the Handlebar so
that it does not fall.
2.
Remove the Handlebar and Footpeg. Discard the old
part.
3.
Installation is the reverse procedure.
4.
Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner’s Manual.
Disconnect the data cable from the console before you service this machine.
Replacing the Handlebars and Footpegs
X4
6 mm
A
A