27
E
D
F2
F
F1
G
F
E
A
Note:
Your machine may not match the image. For reference only.
Tools required:
pedal wrench, #2 Phillips screwdriver, 13mm open
end wrench or socket and wrench (or nutdriver), 11mm open end
wrench or socket and wrench (or nutdriver)
1.
Remove the Pedals. Refer to the “Replacing the Pedals”
procedure in this manual.
2.
Carefully remove the Shrouds, Console and Vent Cover. Refer
to the “Replacing the Shrouds and Vent Cover” procedure in this
manual. Set the hardware safely aside for reassembly.
3.
Remove the Front and Rear Fan Covers. Refer to the
“Replacing the Fan Covers” procedure in this manual. Set the
hardware safely aside for reassembly.
4.
Make a note of the setting of the Belt Tensioner (A): the
number of bolt threads showing. To loosen the belt tension, turn the
upper nut (B) and lower nut (C).
5.
Slowly turn the Drive Pulley (D) backward and carefully ease
the Drive Belt (E) off the Drive Pulley to the outside.
Be sure to keep fingers clear of all pinch hazards as
you turn the Drive Pulley.
6.
Carefully move the Fan Assembly (F) forward to disengage
from the Main Frame brackets (G) on both sides. Remove the Drive
Belt (E) from the Fan Assembly pulley (F1).
7.
Remove the old Fan Assembly (F) and discard it.
Disconnect the data cable from the console before you service this machine.
Replacing the Fan Assembly and Fan Tensioner Assemblies
A
B
C
